Cary Audio Design SLP 74P Preamplifiers

Cary Audio Design SLP 74P Preamplifiers 


- Capacitors: Polypropylene Power Supply Capacitors: 8 ea - individual R/C high voltage isolated networks.
- AC Cord: 3 Conductor, Detachable.
- AC Power Requirements: 117/234 VAC @ 50/60 Hz Consumption 40 Watts Operation 15 Watts Standby.
- Warm-Up Time: 3 Minutes.
- Break-In Time: 100 Hours.
- Finish: Black Anodized Aluminum Faceplate, Black Epoxy Coated Aluminum Chassis, Optional Remote - Volume Control.
- Gain, Line Level: 15 dB.
- Gain, MM Section: 80 dB.
- Noise and Hum: -90 dB below full outpu.
- Circuit Type: Single-Ended Triode, Class A.


Showing 1-1 of 1  
[Aug 08, 2003]
Casual Listener


Sounds right and easy listening especially with the Millards. Positioning is good and overall neutral.


The time delay switch can produce a "pop" noise if speakers are on. Need good isolation and firm support without resonance.

Good preamp. When I first set it up I was through with an ARC SP-7; sound seemed "dark" at first but when listening more, the bright "highs" were not there and lots of details and stage. Bass is significantly better and clean. Good low noise floor but still some (I do not ground it) when comparing with CJ-12A. Not test on the phono as I play mostly CDs.

Similar Products Used:

CJ-12A, ARC SP-7, DB-2

Showing 1-1 of 1  

(C) Copyright 1996-2018. All Rights Reserved. and the ConsumerReview Network are business units of Invenda Corporation

Other Web Sites in the ConsumerReview Network: | | | |